13
Disconnection of AUTOMAX:
If you do not wish to use AUTOMAX,
observe the following procedure:
1. Turn the control button to A
OFF
.
2. Then turn the control button to the
required setting.
Setting the large zone on the
double zones
1. Turn the control button to
The display will show:
2. Then turn the control button to the
required setting (e.g. setting 9).
If you wish to disconnect the large
zone, turn off the zone and then turn
the control button to the required
setting.
Child safety device
Connection and disconnection of the
child safety device is described in the
section entitled “Before use”.
When the child safety device is
activated the display will show:
20
Minimum distance
to side wall:
150 mm
Minimum distance
to rear wall (non-
flammable material):
50 mm
Reinforcement
beams
Installation
Caution: In order to avoid a hazard this
appliance must be installed according to
these instructions for installation
The appliance unit can be mounted in
any type of kitchen with a work top
whose thickness is between 28 mm and
40 mm.
Clearance
The distance between the top side of the
work top and the carpentry underneath
must be at least 47 mm.
Fixing
Screw the fixing brackets out to such an
extent that they can be turned in under
the work top. Tighten the brackets on to
the work top with an ordinary
screwdriver.
Cut-out measurements
One rectangular hole is sawn out for the
appliance combination chosen.
The depth of the cut-out for any unit is:
490 mm
Length of hole = sum of all units`
externally measured length, less 20 mm.
Mounting of Reinforcement
Beams
A reinforcement Beam, with supporting
flanges at each end, is included with
each two-burner unit. For unit
combinations, a reinforcement beam
must be used between each unit.
Min. 47 mm
