B
1.
Install the anti-tilt protection (A) on
the wall.
Make sure that the wall is made of a
solid material. If not, you need to
make the wall sufficiently strong to
hold the weight.
Make sure that the surface behind
the appliance is smooth.
2.
Put the appliance in the middle of
the space between the cupboards.
If the space is larger than the width
of the appliance, you must adjust the
side measurement.
3.
Install the anti-tilt protection (A)
approximately 77 mm below the top
surface of the appliance and 50 mm
from the left or right side of the
appliance into the circular hole on
the bracket. Screw it into the wall.
50 mm
77 mm
A
4.
Check that the anti-tilt protection (A)
fits minimum 20 mm into the hole in
the rear wall of the appliance (B)
when you push the appliance.
13.5
Electrical installation
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
13.6
Covering terminal board
• The recommended cross-section area
is six square millimetres (6 mm²).
• When you refit the mains terminal
cover, make sure that the lower tabs
are located inside the bottom edge of
the aperture, before you fix the two
screws into the top edge of the mains
terminal cover.
• Make sure that the cover is securely
fastened.
To open the cover of
terminal board obey the
procedure in opposite
sequence.
13.7
Terminal board
Do not remove blanking
plates.
Make sure that the links are fitted as
shown.
N
N
N
L
L
www.aeg.com
36
Содержание 49176V-MN
Страница 1: ...EN User Manual Cooker 49176V MN ...
Страница 38: ...www aeg com 38 ...
Страница 39: ...ENGLISH 39 ...
Страница 40: ...www aeg com shop 867307152 B 352014 ...