AEG 47132MM-MN, Руководство пользователя

Страница: 10 / 32

5.2 Ignition of the hob burners
Always light the burner
before you put on the
cookware.
WARNING!
Be very careful when you use
open fire in the kitchen
environment. The
manufacturer declines any
responsibility in case of the
flame misuse.
1. Turn the knob for the hob to the
position and push it down. When
you push the knob, the spark
generator activates automatically.
2.
Keep the knob for the hob pushed
for equal or less than 10 seconds to
let the thermocouple warm up. If not,
the gas supply is interrupted.
3. Adjust the flame after it is regular.
WARNING!
Do not keep the knob
pushed for more than 15
seconds. If the burner does
not light after 15 seconds,
release the knob, turn it into
the off position and try to
light the burner again after
minimum 1 minute.
If after some tries the burner
does not light, check if the
crown and its cap are in the
correct position.
In the absence of electricity
you can ignite the burner
without an electrical device.
In this case approach the
burner with a flame, push
the relevant knob down and
turn it to maximum position.
Keep the knob pushed for
equal or less than 10
seconds to let the
thermocouple warm up.
If the burner accidentally
goes out, turn the knob to
the off position and try to
light the burner again after
minimum 1 minute.
The spark generator can
start automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
5.3 Replacing burner parts
1. Put carefully the burner crown on the
burner body. Let the crown fall freely
onto the body. Do not use force.
Make sure that the hole in the crown
is above the ignition candle.
Make sure that the location pegs are
in the slots in the burner body.
Make sure that you can move the
crown a small distance from side to
side.
2.
Put the burner cap centrally on top of
the crown (enamel side up).
Make sure that the cap is correctly
installed and you can move the cap
from side to side and front to back.
3. Try to light the burner.
If the burner does not ignite, adjust the
crown and cap again.
5.4 Turning the burner off
To put the flame out, turn the knob to
the off position .
WARNING!
Always turn the flame down
or switch it off before you
remove the pans from the
burner.
5.5
Lid Safety Device
Lid has safety device, which cuts off the
gas supply for the hob. It works only
when the lid is closed.
WARNING!
Always use the knob for the
hob to switch off a burner.
Do not use the lid as a cut-
off device.
www.aeg.com 10