AEG Electrolux Lavamat 46210, Руководство пользователя

Страница: 27 / 39

Operating problems 27
the wash cycle is much too
long: •the water inlet filters are dirty,
•the power or water supply has been cut off,
•the motor overheating detector has been activated,
•the water inlet temperature is lower than usual,
•the foam detection security system has been activated
(too much detergent) and the washing machine has
begun draining the foam,
•the out of balance detector has been activated : an
extra phase has been added to distribute washing more
evenly in the drum.
The washing machine stops
during a wash cycle : •the water or electricity supply is defective
•a Rinse hold has been selected,
•the drum shutters are open.
The lid doesn’t open at the end
of the cycle : •the “immediate opening”
*
light is not lit,
•the temperature inside the drum is too high,
•the lid unlocks 1 - 2 minutes after the end of the
cycle*.
The E40 error code appears in
the display
**
and the START/
PAUSE pushbutton flashes in
yellow
***
:
•the lid isn’t closed properly.
The E20 error code appears in
the display** and the START/
PAUSE pushbutton flashes in
yellow*** : •the drainage filter is obstructed,
•the drain hose is blocked or bent,
•the drain hose is fixed too high (see “Installation”
section).
•the drainage pump is blocked,
•the standpipe is blocked.
The E10 error code appears in
the display** and the START/
PAUSE pushbutton flashes in
yellow*** : •the water inlet tap is closed,
•the water supply has been cut off.
The EF0 error code appears in
the display** and the START/
PAUSE pushbutton flashes in
yellow*** : •the drainage filter is obstructed,
•the anti-flooding security system has been activated,
please proceed as follows :
- close the water inlet tap,
- empty the appliance for 2 minutes before unplugging,
- call the after-sales service.
The drainage pump runs
constantly, even when the
appliance is inactive : •the anti-flooding security system has been activated,
please proceed as follows :
- close the water inlet tap,
- empty the appliance for 2 minutes before unplugging,
- call the after-sales service.
Problems Causes