12
Important!
The first time you use the washing machine
,
when you switch it on, it may display a blinking zero and
give an audible warning signal. This is due to the fact
that the washing machine has performed a washing
cycle during the manufacturer’s inspection tests, and
this cycle has not been erased after its completion.
•
Delay start
, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the START/PAUSE button,
the countdown begins, and the delay time value
decreases by one unit every hour.
You can delay the start of the selected programme
by up to 24 hours in one hour intervals.
•
An incorrect option selection has been made
:
this is indicated by the message
Err
when a
function incompatible with the current programme
is selected.
The incorrect selection is also indicated by an
audible warning signal.
•
An alarm code
indicates a fault in the machine
operation (see the relevant chapter on page 23).
E20
9 START/PAUSE button
This button has three functions:
•
Start
: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
If you have selected a delay time by means of the
relevant button, the countdown will begin and will
be shown on the display.
•
Pause
: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, the DOOR LOCKED
light goes out, and it becomes possible to open the
door, provided
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
Important!
You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
•
Draining of water and spinning
after the
execution of programmes with the RINSE HOLD
option .
10 RESET button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the washing machine on, the blinking zero will
reappear and the audible warning signals relevant to
the end of the previous cycle will be given.
You can also press the RESET button to exclude
one or several phases of the programme which is
running, as indicated below.
- set the washing machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the RESET button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the name of the phase(s) will go out).
132998250.qxd 1/14/02 8:53 AM Pagina 12 (Nero/Process Black pellicola)
