AEG Electrolux EU 1921 C Скачать руководство пользователя страница 4

Страница: 4 / 10

INSTALLATION

If this appliance featuring magnetic door seals is
to replace an older appliance having a spring lock
(latch) on the door or lid, be sure to make that
spring lock unusable before you discard the old
appliance. This will prevent it from becoming a
death-trap for a child.

Location

TThe appliance should be installed well away from
sources of heat such as radiators, boilers, direct sun-
light etc.
Best performance is obtained with ambient tempera-
ture b18

C and +43

C (class T); +18

C and

+38

C (class ST); +16

C and +32

C (class N); +10

and +32

C (class SN).

The class of your appliance is shown on its rating
plate.

For safety reasons, minimum ventilation must be as
shown in Fig. 1:

Appliance positioned under overhanging kitchen wall
units (see Fig. 1-A).

Appliance positioned without overhanging kitchen
units (see Fig. 1-B).

Attention: keep ventilation openings clear of ob-
struction.

Two adjustable feet at the cabinet base allow accurate
levelling of the appliance.

Fig. 1

D524

min.
50 cm

Rear spacers

The plastic bag containing all relevant documentation
also contains two spacers to be fitted into special
holes in the back of the appliance.
Fit the spacers into the holes, taking care to ensure
that the arrow (A) is positioned as shown in Fig. 2.
Then turn them through 45

(arrow (A) vertical) until

they lock into place.

Fig. 2

Power connection

Before plugging in, ensure that the voltage and fre-
quency shown on the serial number plate correspond
to your domestic power supply.
Voltage can vary by

6% of the rated voltage.

For operation with different voltages, a suitably sized
auto-transformer must be used.

The appliance must be earthed.

The power supply cable plug is provided with a con-
tact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in compli-
ance with current regulations, consulting a specialist
technician.

The Manufacturer declines all responsibility if the
above safety precautions are not observed.

This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio inter-
ference suppression.

This appliance complies with the following
E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modifications;

- 89/336 EEC of 3.5.89 (Electromagnetic Compatibil-

ity Directive) and subsequent modifications.

Cleaning the appliance’s interior

Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these
will damage the finish.

D060

45°