42
Building the appliance in under a
worktop
This appliance can also be built in under the worktop
of your kitchen units. To do this, proceed as follows
(Fig. 2):
remove screws which secure the top to the rear
brackets and front hinges;
move the top slightly to release it from the retainers
and remove it;
unscrew the screws securing the rear feet to the
cabinet;
remove the 3 mm shim from the feet and refit them;
screw in the front feet to obtain the required height.
Important
For the appliance to function properly, an opening of at
least 137 cm
2
(Fig. 3) must be cut in the kitchen
worktop.
A minimum clearance must also be provided between
the condenser and the wall, as shown in the Fig. 4.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by
±
6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
Fig. 3
Fig. 4
D219
min 137cm
2
PR122
60 mm
min.
50 cm
2
TECHNICAL SPECIFICATION
The technical data is indicated in the rating plate on the left side inside the appliance.
GB
