19
Error code
The Oven Electronic Control does a continuous
diagnostic check of the system. If some
parameters are not correct, the control unit
will stop the activated functions and the
corresponding error code will be displayed.
"Beep" Mode
You can choose to make The Electronic Control
beep each time that a control is touched.
To enable this function, the oven must be off.
1. Press controls
and
at the same time
for about 3 seconds. The Electronic Control
beeps once (Fig. 22).
To disable the "Beep" Function:
1. If the oven is on, touch control
to switch
it off.
2. Press controls
and
at the same time
for about 3 seconds. The Electronic Control
beeps once
Fig. 22
Some recipes have been stored into the Oven
Electronic Control memory to allow you to cook ten
different dishes using pre-set cooking functions,
temperatures and cooking times.
The available recipes are listed at the bottom of the
following page.
To choose a recipe:
1. Touch the ON/OFF control
to switch on
the oven;
2. Touch the "Recipe Selection Function" control
: the upper section of the display will show
the name of the recipe, and symbol will
come on near the "Cooking Duration" symbol
. This means that a cooking duration is
already set in the memory. The lower section
will show the symbol of the pre-set cooking
function and the pre-set cooking temperature.
Symbol " " will flash at the right hand of the
temperature display. (Fig. 23).
The "Recipe Selection" Function
Fig. 23
