AEG Electrolux 78001KF-N, Инструкция по установке и эксплуатации

Страница: 23 / 32

23
If you are unable to remedy the problem by following the above
suggestions, please contact your local Service Force Centre.
1
Warning! Repairs to the appliance are only to be carried out by quali-
fied service engineers. Considerable danger to the user may result from
improper repairs.
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5
seconds another acoustic
signal sounds The On/Off sensor field has
been covered up, e.g. by a
cloth Do not place any objects
on the control panel
Display changes between
two heat settings Power Management is re-
ducing the power of this
cooking zone See the section “ Switching
the power function on and
off”
Power Management is ac-
tive, maximum load per
side reached Use cooking zones on other
side
f
flashes Unsuitable cookware Use suitable cookware
No cookware on the cook-
ing zone Put cookware on zone
Diameter of the base of the
cookware is too small for
the cooking zone Use suitable cookware
(min. 120 mm)
Cookware not completely
covering cross Place cookware centrally
over the cross
_
is lit Overheating protection for
the cooking zone has been
triggered Switch off the cooking
zone. Switch the cooking
zone on again
Safety cut-out has been
triggered Switch off the cooking
zone. Switch the cooking
zone on again
e
and number are dis-
played
Electronics fault Disconnect the appliance
from the electrical supply
for a few minutes (Take the
fuse out of the house’s wir-
ing system)
If after switching on again,
e
is displayed again, call
the customer service de-
partment
Problem Possible cause Remedy