User Manual NS1500/2200/3000-1T
6
Rev. 11/2005
3. Installation
3.1 Unpacking
Examine the packing carton for damage. Notify the carrier immediately if damage is
present. Retain the package for future use.
3.2 Installation
1. Before making any connection and switching on the UPS, please check the
following conditions: (1) your AC power source should be 120 volts and 60Hz and
(2) all the equipment connected to the UPS does not exceed the maximum output
power of the UPS (as indicated on the UPS rear panel and specifications shown
in Section 7).
2. Connect the power cord of the UPS to a working, grounded AC wall socket.
3. Charge the batteries for 8 hours before use. When the power cord is plugged
into the wall outlet and AC power is available, the UPS will automatically recharge
its batteries. You may use the UPS immediately without recharging, but the
backup time may be less than the rating.
4.
Connect the power cord of your equipment to the output receptacles of the UPS.
Check the type of power cord before
connecting the plug to the outlet. The
power cord plug should mate with the
outlet.
