holder.
Note!
Use
attached bit holder to hold 25 mm
bits
,do not use double-end crewdriver bits which
are long than 25mm.
■
Caution!
Apply the power tool to the screw/nut only when it is
switched off.
■
On/Off switch:
To switch on the screwdriver by pressing
On/Off switch and keep it depressed. The head LED lights up
when
“switch on” enable to illuminate poorly area. Release the
switch ,the screwdriver will stop and
head
LED extinguish
within 30 seconds
.
Also the trigger lights up when switch on,and it
extinguish at the itme of releasing switch.
■
Direction of rotation:
Push the rotation direction switch
onward for clockwise rotation, and backward for left
anti-clockwise rotation.
■
Spindle locking:
When the On/Off switch is released or set
up
rotation direction switch to
“0”, the is locked. This enables
screws to be screwed in, even when the battery is empty and
allows for the using as a manually screwdriver.
■
Attention!
Use only screwdriver bits that fit properly in the
head of the screw. And, when driving in larger and/or longer
screws in hard workpieces, it is advisable to drill a pilot hole
first.