
Let’s Get Started
Carefully unwrap all components. Check for any missing or damaged
parts. If a part is damaged or missing, notify your retailer immediately
to ensure prompt replacement.
TIP!
Save the box! It’s great to reuse when traveling with your filtration
system.
Filtration System Assembly
1. Soak #7 4-Layer Earth Filter and #2 Micro Ceramic Filter in cold water
for a minimum of 15 minutes.
2. While soaking filters, hand-wash remaining parts with mild soap and
rinse thoroughly.
NOTE:
Filtration components are not dishwasher
safe.
3. Flush #7 4-Layer Earth Filter by holding upright under cold running
water for approx. 15 seconds and allow excess water to drain off.
4. Attach #3 O-Ring onto #2 Micro Ceramic Filter.
5. Insert #2 Micro Ceramic Filter into #4 Top Tank and fasten with #5
Nut. Do not over-tighten.
6. Twist #7 4-Layer Earth Filter counter-clockwise into #6 Plastic Plate.
7. To assemble #10 Spigot, attach #11 Silicon Ring onto #10 Spigot;
insert #10 Spigot into opening of #9 Bottom Tank; attach #12 Silicon
Ring onto #10 Spigot. Screw on #13 Spigot Nut. Do not over-tighten.
8. Stack system sections as they appear on Component Diagram.
9. Test #9 Bottom Tank for leaks. Fill Bottom Tank with water until it
covers the #10 Spigot. If a leak occurs, you may need to retighten or
realign the #11/#12 Silicon Rings.
Filling Filtration System With Water
Once you have washed and assembled your filtration system you may
begin filling it with water. Fill with Adya treated water or add the
appropriate amount of Adya Clarity (see directions on bottle) to the Top
Tank while filling.
• Top Tank holds 5 L (1.3 gallons). Bottom Tank holds 10 L (2.6 gallons).
Component Diagram
Revised 012/14
1. Lid
2. Micro Ceramic
Filter
3. O-Ring
4. Top Tank
5. Nut
6. Plastic Plate
7. 4-Layer
Earth Filter
8. Bottom
Tank Cover
9. Bottom
Tank
10. Spigot
11. Silicon Ring
12. Silicon Ring
13. Spigot Nut
14. Base
Support