advidia A-44-IR V2, Быстрый старт

Страница: 13 / 26

A-44 V2/A-54 V2
·
Quick Start Guide
13
● Dust or grease on the dome cover will cause IR reflection.
Please do not remove the dome cover film until the installation
is finished. If there is dust or grease on the dome cover, clean
the dome cover with clean soft cloth and isopropyl alcohol.
● Make sure that there is no reflective surface too close to the
camera lens. The IR light from the camera may reflect back into
the lens causing reflection.
● The foam ring around the lens must be seated flush against the
inner surface of the bubble to isolate the lens from the IR LEDS.
Fasten the dome cover to camera body so that the foam ring
and the dome cover are attached seamlessly.
Steps:
1. Drill the screw holes and the cable hole according to the supplied
drill template.
Figure 2-1
Drill Template
(Optional)Routing the cable from the side outlet instead of the
cable hole drilled on the ceiling is supported. Use pliers to remove
BOTTOM
Hole
2
2
1
1
1
1