AdvenChair Field Guide
Page 11
Figure 8. Controls for adjusting seat position and angle (dump) of the seat bucket.
Note: There are five seat angle adjustment holes. Two are shown and three are hidden.
3.
Footrest:
a.
Angle of the footrest assembly:
The tube supporting the footrest assembly has three
positions: 22, 38, and 45 degrees forward from vertical. Pull the red pin on both sides,
choose the angle most comfortable for the rider, and re-pin both sides. Taller riders will
need the footrest angled farther forward.
b.
Height of the footrest assembly:
The tube supporting the footrest assembly telescopes
and can be lengthened or shortened. Pull the green detent pins from the tubes on both
sides, raise or lower the footrest assembly to a comfortable height, and re-pin both
sides.
c.
Angle of the footrest tray:
At the top, back of the footrest tray, there is a blue detent
pin on each side and three holes in the each side of the footrest tray. Pin the footrest
tray to a comfortable angle by placing the yellow detent pin through the appropriate
hole on both sides.
d.
Strap the rider’s feet into the footrest:
Buckle the footrest straps together over the
rider’s feet and pull snug. (The footrest straps are on both the standard footrest and
the optional upper footrest and are not shown.)