Advantech UNO-1110, Быстрый старт

Страница: 21 / 24

11 UNO-1110 Quick Start Guide
Chapter 2
Installation
UNO-1110 also provides two digital outputs connection, please refer below figure
shows how to connect digital output function. (The default DO status is high)
Figure 2.6 Digital Output Connections
2.7 Simulation DI
UNO-1110 provides four simulation DI lines via DIP switch setting located on the top
side of UNO-1110.
Simulation DI is user-friendly design for users to setup different system parameters /
configuration according to DIP switch setting.
2.8 USB Connector
The USB interface supports Plug and Play, which enables you to connect or discon-
nect a device whenever you want, without turning off the computer.
The UNO-1110 provides four connectors of USB interfaces, which gives complete
Plug & Play and hot swapping for up to 127 external devices. The USB interface
complies with USB EHCI, Rev. 2.0 compliant.
Table 2.7: Simulation DI Setting
DIP Switch Logic
ON 0
OFF 1
Note! If use high power USB device, it is better plug-in device before system
turn-ON.
Table 2.8: USB Connector Pin Assignments
Pin Signal Name Cable Color
1 VCC Red
2 DATA- White
3 DATA+ Green
4 GND Black