iii
Safety Instructions
1.
Please read these safety instructions carefully.
2.
Please keep this User’s Manual for later reference.
3.
Please disconnect this equipment from AC outlet before cleaning.
Don’t use liquid or sprayed detergent for cleaning. Use moisture
sheet or clothe for cleaning.
4.
For pluggable equipment, the socket-outlet shall be installed near the
equipment and shall be easily accessible.
5.
Please keep this equipment from humidity.
6.
Lay this equipment on a reliable surface when install. A drop or fall
could cuase injury.
7.
Do not leave this equipment in an environment unconditioned,
storage temperature above 50 C, it may damage the equipment.
8.
The openings on the enclosure are for air convection hence protects
the equipment from overheating. DO NOT COVER THE
OPENINGS.
9.
Make sure the voltage of the power source when connect the
equipment to the power outlet.
10.
Place the power cord such a way that people can not step on it. Do
not place anything over the power cord. The power cord must be
rated for the product and f0or the voltage and current marked on the
product’s electrical ratings label. The voltage and current rating of
the cord should be greater than the voltage and current rating marked
on the product.
11.
All cautions and warnings on the equipment should be noted.
12.
If the equipment is not use for long time, disconnected the equipment
from mains to avoid being damaged by transient over-voltage.
13.
Never pour any liquid into ventilation openings. This could cause
fire or electrical shock.
14.
Never open the equipment. For safety reason, qualified service
personnel should only open the equipment.
15.
If one of the following situations arises, get the equipment checke3d
by service personnel:
a.
The power cord or plug is damaged.
b.
Liquid has penetrated into the equipment.
c.
The equipment has been exposed to moisture.
d.
The equipment has not work well or you can not get it
work according to user’s manual.
Содержание SG-1003
