2 2
RAID-800S User's Manual
6. Connect the SCSI ID Selector cable. If there are any jumpers installed
in your drive’s SCSI ID connector, remove them now. Connect the
cable to the hard drive according to the table shown on the next
page.
Cable
Orange
Black
HDD LED
+
-
3.2.3 Installation
Your subsystem supports hot-swapping allowing you to install or
replace your hard drive while the subsystem is running.
1. Pull out an empty mobile rack. (You can install in any available slot.)
Refer to section 1.4 for the locations of the mobile racks.
2. Static electrical discharge can damage your drive or other compo-
nents without causing any signs of physical damage. To provide
ESD protection, ground yourself by touching the metal part of the
subsystem chassis.
3. Unpack your hard drive. Before installing the drive into the rack, you
must first disable the drive’s terminator. Refer to your hard drive’s
manual for instructions on disabling the terminator.
4. Remove the top cover of the cartridge. The cover is snapped
securely onto the cartridge. In some cases, you may need to exert
slight force to remove the cover. Refer to section 1.4.2 (figure 1-6) for
the internal structure of the mobile rack.
5. Connect the Drive Activity (HDD LED) cable. If it is incorrectly
installed, the LED will not light.
Содержание RAID-800S
