Advantech PCL-725, Руководство пользователя

Страница: 11 / 18

PCL-725 Installation
Isolated Non-isolated
-------- ------------
JA1 o o I JA1 o o I
o o N o o N
JB1 o o I JB1 o o I
o o N o o N
To configure channel 1 as isolated, the jumper plugs are installed on the upper
posts of JA1 and JB1. Otherwise, jumper plugs should be installed on the
lower posts to configure channel 1 as non-isolated.
2.5. Installing The PCL-725
POWER MUST ALWAYS BE SWITCHED OFF when removing or
inserting the PCL-725 card and connecting or disconnecting cables.
Use a screw driver to remove the cover mounting screws from the rear of the
system unit.
Slide the system unit's cover away from the rear and to the front. When the
cover will go no further, tilt it up, remove it from the base, and set it aside.
The PCL-725 is configured at the factory for the IBM PC, PC/XT, PC/AT and
all IBM PC compatibles. If you need further changes to the configuration
please refer to Chapter 2. Installation.
Use a screw driver to remove the screw that secures the expansion slot cover.
Save the screw for installation of the interface card.
The 37 pin connector should be pressed through the rear panel first, then press
the card carefully into the main board expansion slot.
Secure the PCL-725 with the 3/16" mounting screw, then attach an appropriate