PCI-7030 Startup Manual
Jumpers and Connectors
The board has a number of connectors and jumpers that
allow you to configure your system to suit your application.
The table below lists the function of each of the connectors
and jumpers.
Connectors
Label
Function
JFP1(1-2)
HDD LED connector
JFP1(3-4)
Power LED connector
JFP1(5-6)
Suspend LED connector
JFP1(7-8)
Reset connector
JFP1(9-10) ATX soft power switch
JFP2(1-2)
FAN fail LED Connector
JFP2(3-4)
Thermal fail LED Connector
JIR1
IR connector
IDE1
IDE connector
CF1
CF Socket
FDD1
FDD connector
LPT1
Parallel port
USB12
USB port 1,2
USB34
USB port 3,4
USB5
USB port 5
SATA1
Serial ATA1
SATA2
Serial ATA2
COM12
Serial Port: COM1 COM2
KBMS1
PS/2 keyboard and mouse connector
KBMS2
External keyboard and mouse connector
VGA1
VGA connector
LAN1
Dual Gigabit Ethernet connector
ATXF1
ATX feature connector
ATX1
ATX power connector
CPUFAN1
CPU FAN connector (3-pin)
SYSFAN1
System FAN connector (3-pin)
HDAUD1
High Definition audio connector
GPIO1
GPIO pin header
BT1
RTC battery connector
DVI1
DVI connector
LPC1
LPC connector
SPI_CN1
SPI flash programming connector
U16
SPI flash socket
SMBUS1
SM BUS connector
LVDS1
LVDS connector
INV1
Inverter connector
Jumpers
Label
Function
CMOS1
CMOS clear
JLVDS1
LVDS voltage selection
JWDT1
Watchdog timer output selection
CMOS1: CMOS clear function
Closed Pins
Result
1-2
Keep CMOS data *
2-3
Clear CMOS
JLVD1: LCD Power 3.3 V/5 V Selector
Closed Pins
Result
1-2*
3.3 V*
2-3
5 V
JWDT1: Watchdog timer output option
Closed Pins
Result
1-2
IRQ11
2-3
System reset *
Software Installation
The CD disc contains a driver installer program that will lead
you through the installation of various device drivers needed
to take full advantage of your CPU card.
Caution
Caution!
The computer is provided with a battery-powered
real-time clock circuit. There is a danger of explo-
sion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended
by Advantech. Discard used batteries according
to manufacturer’s instructions.
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions.
This device may not cause harmful interference.
This device must accept any interference received,
including interference that may cause undesired
operation.
1.
2.
1
2
3
* default setting
1
2
3
* default setting
1
2
3
* default setting
