2 PCE-2029/2129 Startup Manual
The board has a number of jumpers that allow you to con-
figure your system to suit your application. The table below
lists the function of each jumper and connector.
Connector / Jumper List
Label
Function
JWDT1+JOBS1
Watchdog Reset
LPC1
Low pin count connector for Advan-
tech designed LPC modules
LAN1_USB2C1
LAN1 / USB 2.0 Port 7,8
LAN2_USB3C2
LAN2 /
PCE-2129 : USB 3.0 Port5/6
PCE-2029 : USB 2.0 Port5/6
VGA1
VGA connector
HDMI1
HDMI connector
COM1-1
2 x RS232/422/485 (COM1, COM2)
COM3-1
2 x RS232 (COM3, COM4)
JFP1
Power Switch / Reset connector
JCASE1
Case Open connector
PSON1
AT(1-2) / ATX(2-3) mode selector
CPUFAN1
CPU FAN connector (4-pin)
AUDIO1
Audio connector (Line-out, Mic-In)
USB3C1
USB3.0 1/2/3/4
BIOS1
SPI flash card pin header
JCMOS1
CMOS clear
JME1
Intel ME Enable/Disable jumper
GPIO1
8 bit digital I/O connector
SW1
USB power mode and VGA mode
change
USB2H1
USB port (Q170 only)
SW2
Power ON/OFF Switch
DP1
3rd Display output
SATA1/2
Serial ATA1/2
JCFG1
Reserve for RD debug
JSMB1
Reserve for RD debug
JCMOS1: CMOS and ME clear function
Pins
Result
1-2
Keep CMOS data*
2-3
Clear CMOS data
* Default
1
2
3
1
2
3
*Keep CMOS data Clear CMOS data
PSON1: ATX, AT mode selector
Closed Pins
Result
1-2
AT Mode
2-3
ATX Mode*
* Default
JFP1
Closed Pins
Result
1
Power ON/OFF
2,4
GND
3
System Reset
5
Watch Dog Clear
SW1
Switch
State
Setting
SW1-1
1* - 8
LAN1_USB2C1_1 / LAN2_
USB3C2_1 not provide stand by
charging
SW1-2
2* - 7
USB3C1 not provide stand by
charging
SW1-3
3* - 6
USB2H1(Q170 only) not provide
stand by charging
SW1-4
4* - 5
VGA is always on VGA will be ON by
cable detected
JWDT1 + JOBS1
Closed Pins
Result
2-3*
Watch Dog Timer Reset
4-5*
Enable H/W monitor alarm
* Default setting
Caution!
The computer is supplied with a battery-powered
realtime clock circuit. There is a danger of explo-
sion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended
by the manufacturer. Discard used batteries ac-
cording to manufacturer’s instructions.
1
2
3
1
2
3
AT Mode 1-2 closed *ATX Mode 2-3 closed
Jumpers and Connectors
Jumpers and Connectors (Cont.)
