Advantech PCA-6148, Руководство пользователя

Страница: 79 / 108

Appendix A Flash/RAM/ROM disk 71
Booting from the Flash/RAM/ROM disk
If you wish to have the system boot from the Flash/RAM/ROM
disk, simply set driver emulated number for the 1st FDD. Copy
your application files to the disk along with the standard system
files required to boot (command.com, io.sys, msdos.sys, etc). The
next time you start the system, it will boot from the solid state disk.
Inserting memory devices
After you’ve set all the jumpers and switches on the PCA-6148,
insert the appropriate memory devices into the card’s sockets.
Remember that you will need to program EPROMs before you
insert them.
1. Make sure that the pins of the memory chips are perpendicular
to the case and both rows are parallel to each other. Many times
the chips come with the pins spread out slightly. Place the chip
on a table top and carefully bend each line of pins together until
they point directly down.
2. Insert each chip. Align the chips so their pins are perpendicular
to the connector and the semicircular notch on the end of the
chip matches the notch on the end of the socket. There will
probably be a gap between the chip body and the socket when it
is fully seated – Do not push too hard!
3. When installing less than three memory devices, you must first
fill ROM-1SSD.