Advantech PCA-6143P, Руководство пользователя

Страница: 26 / 86

26 PCA-6143P User's Manual
Follow the startup procedure outlined in the manual for your
chassis.
When you start your system, the BIOS will test the hardware and
check the system configuration against the values stored in its
CMOS memory.
Since this is the first time you are starting up, the BIOS will
display an error message stating that the configuration does not
match the stored values. You should then run the BIOS setup
program as described in Chapter 5.
If the BIOS hardware diagnostic tests fail, you may see an error
message on the screen describing the problem. If the BIOS found a
problem early in the tests, you will need to determine the BIOS
POST (Power On Self Test) results by counting beeps or using a
POST card. See Appendix F for details.
The most common source of problems is incorrect jumper settings.
Double check your settings (Chapter 1) and restart the system. If
the system still has problems, see Appendix E, Maintenance and
troubleshooting.
There are three methods you can use to restart your system after it
is turned on:
1. Switch the power off, then on again
2. Reboot the system. Using the keyboard, simultaneously press
the CTL, ALT and DEL keys
3. Depress the optional reset switch
Use of each of these methods will erase data from the system
RAM memory. If you can, save any data stored in memory to a
hard or floppy disk before you reset your system.