Advantech PCA-6005-B, Руководство пользователя

Страница: 26 / 128

PCA-6005-B User’s Manual 14
1.10 Cache Memory
Since the second level (L2) cache has been embedded into the Intel®
Pentium 4/Celeron processor, you do not have to take care of either
SRAM chips or SRAM modules. The built-in second level cache in the
processor yields much higher performance than the external cache memo-
ries. The cache size in the Intel® Pentium 4 processor is 256 KB or 512
KB, for Celeron® processor is 128 KB.
1.11 CPU Installation
The CPU on the board must have a fan or heat sink attached, to prevent
overheating.
1. Make sure the socket 478 lever is in the upright position. To raise
the lever, pull it out to the side a little and raise it as far as it will go.
2. Place the CPU in the empty socket. Follow the instructions that
came with the CPU. If you have no instructions, complete the fol-
lowing procedure. Carefully align the CPU so it is parallel to the
socket and the notches on the corners of the CPU correspond with
the notches on the inside of the socket. Gently slide the CPU in. It
should insert easily. If it does not insert easily, pull the lever up a
little bit more.
1. Press the lever down. The plate will slide forward. You will feel
some resistance as the pressure starts to secure the CPU in the
socket. This is normal and will not damage the CPU. When the
CPU is installed, the lever should snap into place at the side of the
socket.
Warning: Without a fan or heat sink, the CPU will over-
heat and cause damage to both the CPU and
the motherboard. To install a CPU, first turn off
your system and remove its cover. Locate the
processor socket 478.
Note: To remove a CPU, pull the lever out to the side
a little and raise it as far as it will go. Lift out the
CPU.