4 ITA-1711 Startup Manual
1. Read these safety instructions carefully.
2. Keep this User Manual for later reference.
3. Disconnect this equipment from any AC outlet before
cleaning. Use a damp cloth. Do not use liquid or spray
detergents for cleaning.
4. For plug-in equipment, the power outlet socket must
be located near the equipment and must be easily
accessible.
5. Keep this equipment away from humidity.
6. Put this equipment on a reliable surface during installa-
tion. Dropping it or letting it fall may cause damage.
7. Make sure the voltage of the power source is correct
before connecting the equipment to the power outlet.
8. Position the power cord so that people cannot step on
it. Do not place anything over the power cord.
9. All cautions and warnings on the equipment should be
noted.
10. If the equipment is not used for a long time, disconnect
it from the power source to avoid damage by transient
overvoltage.
11. Never pour any liquid into an opening. This may cause
fire or electrical shock.
12. Never open the equipment. For safety reasons, the
equipment should be opened only by qualified service
personnel.
13. If one of the following situations arises, get the equip-
ment checked by service personnel:
•
The power cord or plug is damaged.
•
Liquid has penetrated into the equipment.
•
The equipment has been exposed to moisture.
•
The equipment does not work well, or you cannot get
it to work according to the user’s manual.
•
The equipment has been dropped and damaged.
•
The equipment has obvious signs of breakage.
14. Do not leave this equipment in an environment where
the storage temperature may go below -25° C (-13°
F) or above 60° C (140° F). This could damge the
equipment. The equipment should be in a controlled
environment.
15. Caution:
Danger of explosion if battery is incorrectly
replaced. Deplace only with the same or equivalent
type recommended by the manufacturer, discard used
batteries according to the manufacturer’s instrcuctions.
16. This equipment has been tested and found to comply
with the limits for Class A digital device. Operation of
this equipment in a residential area is likely to cause
harmful interference to radio communications in which
case the user will be required to correct the interfer-
ence.
17. This equipment is sold without power cord. It is recom-
mended to purchase CCC certificated power cord.
The sound pressure level at the operator’s position accord-
ing to IEC 704-1:1982 is no more than 70 dB (A).
DISCLAIMER: This set of instructions is given according
to IEC 704-1. Advantech disclaims all responsibility for the
accuracy of any statements contained herein.
Safety Instructions
Safety Precaution - Static Electricity
Follow these simple precautions to protect yourself from
harm and the products from damage.
1. To avoid electrical shock, always disconnect the power
from your PC chassis before you work on it.
2.
Disconnect power before making any configuration
changes. The sudden rush of power as you connect
a jumper or install a card may damage sensitive elec-
tronic components.
3. Always disconnect the power cord from your chassis
when you are working on it. Do not connect while the
power is on. A sudden rush of power can damage
sensitive electronic components. Only experienced
electronics personnel should open the chassis. Always
ground yourself to remove any static electric charge
before touching motherboard, backplane or add-on
cards. Modern electronic devices are very sensitive to
static electric charges. Use a grounding wrist strap at
all times. Place all electronic components on a static-
dissipative surface or in a static shielded bag.
