Advantech EKI-9228G-8CMI, Руководство пользователя

Страница: 121 / 324

103 EKI-9228G Series User Manual
To access this page, click System > Logs > Configuration.
Figure 4.103 System > Logs > Configuration
The following table describes the items in the previous figure.
Item Description
Buffered Log Configuration
Admin Mode Enable or disable logging to the buffered (RAM) log file.
Behavior Specify what the device should do when the buffered log is full. It can
either overwrite the oldest messages (Wrap) or stop writing new mes-
sages to the buffer (Stop on Full).
Command Logger Configuration
Admin Mode Enable or disable logging of the command-line interface (CLI) com-
mands issued on the device.
Console Log Configuration
Admin Mode Enable or disable logging to any serial device attached to the host.
Severity Filter Select the severity of the messages to be logged. All messages at and
above the selected threshold are logged to the console. The severity
can be one of the following:

Emergency (0): The device is unusable.

Alert (1): Action must be taken immediately.

Critical (2): The device is experiencing primary system failures.

Error (3): The device is experiencing non-urgent failures.

Warning (4): The device is experiencing conditions that could
lead to system errors if no action is taken.

Notice (5): The device is experiencing normal but significant
conditions.

Info (6): The device is providing non-critical information.

Debug (7): The device is providing debug-level information.
Persistent Log Configuration
Admin Mode Enable or disable logging to the persistent log. These messages are
not deleted when the device reboots.
Severity Filter Select the severity of the messages to be logged. All messages at and
above the selected threshold are logged to the console. See the previ-
ous severity filter description for more information about each severity
level.
Syslog Configuration
Admin Mode Enable or disable logging to configured syslog hosts. When the syslog
admin mode is disabled the device does not relay logs to syslog
hosts, and no messages will be sent to any collector/relay. When the
syslog admin mode is enabled, messages will be sent to configured
collectors/relays using the values configured for each collector/relay.