10
2.4
Basic Configuration
2.4.1
Basic Configuration Steps
This section describes a two-step SYSTEM configuration procedure to setup
EKI-6311G.
Step1 : Modify the factory-default parameters on the web page
“/Network/Network/”, and click APPLY to save the changes.
Step2 : Modify the factory-default parameters on the web page
“/WIRELESS/Wi-Fi 1”, and click APPLY to save the changes, than click
“/SYSTEM/Reboot/”Reboot to take effect on the previous configuration
changes.
2.4.2
Logging into the Web Interface
The EKI-6311G supports access to the configuration system through the use of an
HTTP Interface.
►
Web Configuration
Before configuring EKI-6311G, the user needs to know the IP Address assigned to
the unit. When shipped from the factory, the IP Address 192.168.1.1 was
assigned to the EKI-6311G by default. To start a web connection, use
http://192.168.1.1
►
Web Access Procedures
Once you identify the IP Address assigned to EKI-6311G, use web browser to
configure EKI-6311G through the HTTP Interface. The following procedure
explains how to configure each item.
Step1 : Open your browser and enter the IP Address
Step2 : Press <ENTER> key and the EKI-6311G Login screen appears as shown
in Figure 2-5.
