Advantech B+B SmartWorx LR77 v2, Руководство по настройке

Страница: 41 / 135

3. CONFIGURATION
Example
:
If you mark the Switch to default SIM card after timeout check box, and you enter the following
values:
•
Initial Timeout – 60 min,
•
Subsequent Timeout
– 30 min,
• Additional Timeout – 20 min.
The first attempt to change to the primary SIM card or APN is carried out after 60 minutes.
When the first attempt fails, a second attempt is made after 30 minutes. A third attempt is
made after 50 minutes (30+20). A fourth attempt is made after 70 minutes (30+20+20).
3.3.6 Dial-In access configuration
Dial-In access configuration is supported for these routers only: ER75i, UR5, ER75i v2
and UR5 v2.
You may define access over CSD connection by selecting the Enable Dial-In Access func-
tion. Access can be secured by using the Username and Password . If the router does not have
a connection to a mobile network, you may use this function to gain access to the router via
dial-up connections. The router waits two minutes to accept connections. If no one logs on
during this time the router will make another attempt to establish a GPRS connection.
Item Description
Username User name for secured Dial-In access.
Password Password for secured Dial-In access.
Table 24: Dial-In access configuration
3.3.7 PPPoE Bridge Mode Configuration
If you mark the Enable PPPoE bridge mode check box, the router activates the PPPoE
bridge protocol. PPPoE (point-to-point over ethernet) is a network protocol for encapsulating
Point-to-Point Protocol (PPP) frames inside Ethernet frames. The bridge mode allows you to
create a PPPoE connection from a device behind the router. For example, a PC connected to
the ETH port of the router. You assign the IP address of the SIM card to the PC.
The changes in settings will apply after clicking the Apply button.
34