2-9
Hardware Setup
44-Pin EIDE Connector: IDE1
This 44-pin EIDE connector connects to an optional converter that enables connection
to one 44-pin EIDE device and one 40-pin EIDE device, such as hard disk drives, CD-
ROM and other EIDE devices.
Important
If you install two hard disks on cable, you must configure the second drive to
Slave mode by setting its jumper. Refer to the hard disk documentation sup-
plied by hard disk vendors for jumper setting instructions.
Chassis Intrusion Switch Connector: JCI1
This connector connects to a 2-pin chassis switch. If the chassis is opened, the switch
will be short. The system will record this status and show a warning message on the
screen. To clear the warning, you must enter the BIOS utility and clear the record.
JCI1
1
2
CHASSIS
GND
IDE1
Connect to EIDE1
Connect to 40-pin
EIDE device
Connect to 44-pin
EIDE device
Connectors
