Advantech AGS-910, Руководство пользователя

Страница: 4 / 94

AGS-910 User Manual iv
Safety Information
Retain and follow all product safety and operating instructions provided with your
equipment. In the event of a conflict between the instructions in this guide and the
instructions in equipment documentation, follow the guidelines in the equipment doc-
umentation.
Observe all warnings on the product and in the operating instructions. To reduce the
risk of bodily injury, electric shock, fire and damage to the equipment, observe all pre-
cautions included in this guide.
You must become familiar with the safety information in this guide before you install,
operate, or service Advantech products.
Machine Room Environment

Make sure that the area in which you install the system is properly ventilated
and climate-controlled.
 Ensure that the voltage and frequency of your power source match the voltage
and frequency inscribed on the electrical rating label of the equipment.

Do not install the system in or near a plenum, air duct, radiator, or heat register.
 Never use the product in a wet location.
Equipment Chassis
 Do not block or cover the openings to the system.
 Never push objects of any kind through openings in the equipment.
 Dangerous voltages might be present.
 Conductive foreign objects can produce a short circuit and cause fire, electric
shock, or damage to your equipment.

Lift equipment using both hands and with your knees bent.
Rack Mount Instructions
The following or similar rack-mount instructions are included with the installation
instructions:
 Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly,
the operating ambient temperature of the rack environment may be greater than
room ambient. Therefore, consideration should be given to installing the equip-
ment in an environment compatible with the maximum ambient temperature
(Tma) specified by the manufacturer.
 Reduced Air Flow - Installation of the equipment in a rack should be such that
the amount of air flow required for safe operation of the equipment is not com-
promised.
 Mechanical Loading - Mounting of the equipment in the rack should be such that
a hazardous condition is not achieved due to uneven mechanical loading.
 Circuit Overloading - Consideration should be given to the connection of the
equipment to the supply circuit and the effect that overloading of the circuits
might have on overcurrent protection and supply wiring.
 Appropriate consideration of equipment nameplate ratings should be used when
addressing this concern.
 Reliable Earthing - Reliable earthing of rackmounted equipment should be
maintained. Particular attention should be given to supply connections other
than direct connections to the branch circuit (e.g. use of power strips)."