OWNER’S MANUAL
EVOLUTION 5200, 6400, 7800 & 9600
SERIES PUMPS
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should
always be followed, including the following:
1. READ AND FOLLOW ALL INSTRUCTIONS
2. WARNING
– To reduce the risk of injury, do not permit children to use this
product unless they are closely supervised at all times.
3.
Do not install within an outer enclosure unless so marked.
4. SAVE THESE INSTRUCTIONS.
WARNING
– All electrical wiring of the motor installation must be done by a qualified
electrician in accordance with applicable electrical codes. Before working on any motor,
be certain that the source of electrical power is off at the main junction box.
BONDING WIRE
– Upon installation of the pump, the motor must be used with a No. 8
AWG (8.4mm2) solid copper conductor per National Electric Code. The connection
should be from the accessible wire connector on the motor to all metal parts of the water
garden and to all electrical equipment, metal conduit and metal piping within 5 feet
(1.5m) of the inside walls of the water garden, when the motor is installed within 5 feet of
the inside walls of the water garden.
NOTE:
For electrical connection, see wiring diagram on motor rating plate.
CAUTION:
This Pump Has Been Evaluated for Use With Water Only.
WARNING Risk of Electric Shock
– This pump is supplied with a grounding conductor
and grounding-type attachment plug. To reduce the risk of electric shock, be certain that
it is connected to a properly grounded, grounding-type receptacle. (56.1 b)
