19
PROBLEM CAUSE
REMEDY
Pump will not pump System pressure too high
Check system pressure to assure that it is within
system rated paramaters of the pressure.
Diaphragm improperly installed
Make sure that diaphragm is screwed fully
unto shaft.
Check valves worn or clogged
Clean or replace as required.
Pump will not run
Pump not turned on or not plugged in
Check outlet with meter to assure the correct voltage
or not plugged in
is present and that power supply cord is in good
condition and plugged in.
See page 5.
Electronic failure
Consult dealer or factory.
Excessive noise
Pump not primed
Prime pump.
No output pressure
Add an anti-siphon valve to provide 25 PSI
restriction on pump discharge.
X. Manufacturer’s Product Warranty
Advantage Controls warrants units of its manufacture to be free of defects in material or workmanship. Liability
under this policy extends for 24 months from date of installation. Liability is limited to repair or replacement of
any failed equipment or part proven defective in material or workmanship upon manufacturer’s examination.
Removal and installation costs are not included under this warranty. Manufacturer’s liability shall never exceed
the selling price of equipment or part in question.
Advantage disclaims all liability for damage caused by its products by improper installation, maintenance,
use or attempts to operate products beyond their intended functionality, intentionally or otherwise, or any
unauthorized repair. Advantage is not responsible for damages, injuries or expense incurred through the
use of its products.
The above warranty is in lieu of other warranties, either expressed or implied. No agent of ours is authorized
to provide any warranty other than the above.
30 Day Billing Memo Policy
Advantage Controls maintains a unique factory exchange program to ensure uninterrupted service with
minimum downtime. If your unit malfunctions, call 1-800-743-7431, and provide our technician with Model
and Serial Number information. If we are unable to diagnose and solve your problem over the phone, a fully
warranted replacement unit will be shipped, usually within 48 hours, on a 30 Day Billing Memo.
This service requires a purchase order and the replacement unit is billed to your regular account for
payment.
The replacement unit will be billed at current list price for that model less any applicable resale discount.
Upon return of your old unit, credit will be issued to your account if the unit is in warranty. If the unit is out of
warranty or the damage not covered, a partial credit will be applied based upon a prorated replacement price
schedule dependent on the age of the unit. Any exchange covers only the controller or pump. Electrodes,
liquid end components and other external accessories are not included.
