13
-- DIAGNOSTICS --
MODEL # DAGF
FIRMWARE V.(n)
TEST DISPLAY
Display will flash (all spaces should
lig
ht) press ENTER again to finish
test
TEST KEY PAD
Key on keypad pressed,
corresponding number appears
on display, ENTER to quit
RESET CALIBRATE
If pressed resets calibrations to factory
default
MAX PSI:
XXX
Press CLEAR to change
pressure scale
Use numerical keys and then
press ENTER to accept
OUTPUT Pump 1
(Only on DAGF-1 systems.)
T
oggles between pumps
Return to DIAGNOSTICS screen
ENTER
DIAGNOSTICS
This menu is used to select, enter and test the following
items.
MODEL NUMBER
- Read only screen.
FIRMWARE VERSION NUMBER
- Read only screen.
Have both available for service
TEST DISPLAY
- Press ENTER and all pixels will
flash. Make a visual check to see that all pixels are lit.
TEST KEYPAD
- Press ENTER, then press each
individual key to test its function. NOTE: Pressing the
SET UP/RUN key returns display to the main menu.
Pressing ENTER again returns to TEST KEYPAD.
RESET CALIBRATE
- CAUTION! Pressing ENTER
Button here will reset calibration data to factory
defaults. You will need to reset or verify all setting
after doing this.
MAX PSI: XXX
- This allows you to set the maximum
psi. The max setting should correspond to the max
pressure rating of the transducer. On the standard
model, this is 100 psi. This setting allows the controller
to be used with pressure transducers with “other”
output ranges. Press CLEAR to change the pressure
scale. Use numerical keys and then press ENTER to
accept.
OUTPUT Pump 1
(DAGF-1 models only)
This is used in conjunction with feeders with Option
B, dual pump system. This allows the operator to
switch from pump one to pump two when option E is
specified.
ENTER
ENTER
ENTER
CLEAR
ENTER
