Advanjet HV-9500 Series, Техническое обслуживание и ремонт

Страница: 24 / 26

Page 24 of 26 Advanjet HV-9500 Maintenance and Repair 3A5910A
4.2 Prepare the Gap Set Fixture
4.2.1 Check the Zeroing Plate
Make sure the zeroing plate is in place and both
screws are tightly secured.
4.2.2 Zero the MIcrometer
With the zeroing plate tightly secured, remove the
tip protector.

The large dial should read 0.000

The small dial should read 0.300
If large hand does not read zero:

Loosen the bezel lock.

Rotate the outside bezel until the large hand
needle is aligned with zero.

Tighten the bezel lock.

Replace the tip protector.
4.2.3 Remove the
Zeroing Plate
Loosen the two
thumbscrews securing
the zeroing plate.
4.2.4 Attach the Jet
With the mounting plate facing up, use the nozzle plate screws to secure the
jet body to the fixture.