Advanced LAN Bypass, Руководство пользователя

Страница: 73 / 82

63 Advanced LAN Bypass User Manual
Chapter 4
L
BPCU
4.35 /lbpcu -GML
Gets the master/slave mode LED behavior (cf. Section 3.7.11.4).
Example
Figure 4.51 Get the Master/Slave Mode LED Behavior for a BYPASS Action on
Segment 1
4.36 ./lbpcu -RAW
Resets the WDT counter of all segments to the initial countdown value and starts the
timer (cf. Section 3.7.4.3):
Figure 4.52 Usage of the "lbpcu -RAW" Command
Example
Reset the WDT to the initial countdown value and then start the WDT all segments:
Figure 4.53 Start WDT on All Segments
root@localhost:~# ./lbpcu -GML
Get the duty cycle and the period of the Master/Slave Mode LED
to the corresponding actions.
Synatx: GML <the master segment> <action>
action:
CONNECT
DISCONNECT
BYPASS
Output: The duty cycle and the period of the Master/Slave Mode
LED to the corresponding actions
Example: Get the duty cycle and the period of the Master/Slave
Mode LED in BYPASS action.
Example command: ./lbpcu -GML 1 BYPASS
Error: LBP_ERR_PARAM_OUT_OF_BOUND (0x93)
root@localhost:~# ./lbpcu -GML 1 BYPASS
Action:BYPASS
Duty of master LED: 50%
Period of master LED: 0.5 sec
root@localhost:~# ./lbpcu -RAW E
Example: Reset all segments Watchdog counter to the preset
value and start the countdown. So use -RAW will restart count-
down on all segments wdt.
Command: Reset and restart all segments WDT
Syntax: RAW
Output: N/A
Error: LBP_ERR_PARAM_OUT_OF_BOUND (0x93)
root@localhost:~# ./lbpcu -RAW
root@localhost:~#