Advanced Wireless Communications AWR-CB2100, Руководство оператора

Страница: 4 / 8

AWR-CB2100 One-way Call box Operation:
The AWR-CB2100 call box is configured for operation by your radio dealer. Proper frequency information
and operating characteristics are configured using programming software. Your dealer will need to gather
operational information from you before the call box can be deployed. Once configured, the AWR-CB2100
will operate in the following manner:
• The AWR-CB2100 will be in ‘Sleep Mode’ (off) the majority of the time. During ‘Sleep Mode’, very
little current is being consumed allowing for extended battery life.
• A press of the ‘Activate’ button will cause the call box to ‘wake-up’ and perform it’s programmed
duties.
1. A short beep will be heard when the activate button is initially pressed.
2. The ‘Speaker Message on Activation’ greeting message will be heard on the local call box speaker.
3. If the radio channel is not busy, the call box alert tone (if programmed) followed by the ‘Message
on Activation’ will be transmitted to the associated two-way radios. The status LED will be red
when the call box is transmitting.
4. When ‘Awake’, the status LED will flash green when the call box is not transmitting or receiving to
indicate that the call box is active.
5. If the call box reset button is ‘NOT’ pressed, and if the call box is programmed for repeat messages
at a designated time period, the call box will transmit its first repeat message to the associated
two-way radios. This process will continue for the programmed message delay time period and
the number of alert message repeats. If the call box is allowed to progress though all of the
programmed repeats, without being reset, the call box will automatically time-out and re-enter
Sleep Mode.
6. If the Reset button is pressed, while the call box is active, the alert message process is terminated.
7. The call box ‘Speaker Message on Clear’ (if programmed) will be played to the local speaker.
8. The call box ‘Message on Clear’ (if programmed) will be transmitted to the associated two-way
radios.
9. When the call box ‘Message on Clear’ message transmission is complete, the AWR-CB2100 One-
way call box will re-enter ‘Sleep Mode”.
• Low Battery alert
Each time the AWR-CB2100 call box is activated, the battery level is measured. If the battery level has
dropped to a low battery level condition, the call box will process the ‘Low Battery Alert’ message at
the end of each radio alert transmission. The radio users will hear the low battery alert message. The
call box local speaker will not hear the low battery alert message.
• Status LED
1. Call box is active (awake) LED is flashing green
3. Call box is transmitting LED is steady red
4. Call box is in Sleep Mode LED is off