Advanced Radiant Systems RS-30, Инструкция по установке, эксплуатации и обслуживанию

Страница: 11 / 24

Page 7 Residential Range RS_10062016al
INSTALLATION
Cover
2
Right Support
Bracket, Install
Screw on
Bottom Hole
Left Support
Bracket, Install
Screw on
Top Hole
1
Install Both
Top Covers
As Shown,
Then Install
Assembly on
to Heater
Install Bottom
Cover As Shown
Back
Side
Front
5
4
3
Install 45°
Extension
Covers
As Shown
Attach Cover
Bracket
3
A
B
Note:
Close all open ended "S" hooks, chain links,
and turnbuckles or any open connection.
Figure 6: Cover Installation Sequence Steps 1 and 2
Figure 7: Cover Installation Sequence Steps 3 to 5
Cover Installation Sequence
When a heater is installed outdoors without the presence of an adequate eave, then a protective cover must be
installed as illustrated below. This cover is available from your local dealer (Part # RS020).
1. Install support brackets on to heater covers as shown in step 1 in Figure 6.
2. Preassembled the cover and its top covers and bottom cover as shown in step 2 in Figure 6.
3.
Remove the two top screws holding the reflector in place.
4. Slide cover onto burner making sure the support brackets slide into slots on the bottom cover.
5. Secure cover to heater by screwing in the cover bracket in step 3B in Figure 7.
6.
Install the extension covers (Front, Back, and Side) as shown in step 4 in Figure 7 if needed
When a heater is to be installed outdoors at 45° without the presence of an adequate eave, an extension cover
must be used to protect the heater, refer to step 4 in Figure 7. This extension cover is available through your local
Dealer (Part # RS021). Note that both the cover and extension cover must be used in this case (refer to Figure 8
for completed assembly)..