Spatial Reference Manual
Page 61 of 158
Version 4.4
04/06/2019
is only the case when the connectors are mated. When un-mating the connectors if
the Spatial unit is dirty or dusty, the dirt should be rinsed off with fresh water first and
then dried off. This is to prevent dirt or dust entering the connectors which can cause
them to fail.
10.18.5
PH Level
Environments with a high or low PH level can cause the Spatial enclosure to corrode. If
Spatial comes into contact with these environments it should be rinsed in fresh water
as soon as possible. It is not recommended to operate Spatial in non neutral PH
environments.
10.18.6
Shocks
Spatial can tolerate shocks to 2000g, however continuous shocks of this severity are
likely to cause premature failure. Shocks above 2000g can effect the factory sensor
calibration and degrade performance. Normally shocks to Spatial when mounted in a
vehicle are fine. Even a high speed car crash is likely to reach a peak of only 50g.
Shocks directly to Spatial's enclosure can more easily go over the limit however so
care should be taken when handling the unit prior to mounting.