Chapter 3
Configuring settings
30
OsmoTECH XT Single-Sample Micro-Osmometer User Guide
Configuring Service account access (Administrators
only)
Administrators can change user access to the Service
account or disable the Service account by completing
the following steps:
3.
Select the Service account and press
EDIT
.
4.
Select an access level or select
Disabled
to disable
the Service account.
5.
Press
SAVE
.
Connecting to an LDAP server
You can connect your instrument to an LDAP server to
enable users to log into any instrument on the network
with their Windows
®
credentials.
Your network administrator can set up this feature for
you.
1.
Connect the OsmoTECH XT to the network with the
Ethernet connector on the rear of the device (see
Connecting to a network (optional)
).
2.
From SETTINGS, press
USERS > LDAP
.
3.
Select the
LDAP Enabled
checkbox.
4.
Enter the following information:
•
Server IP Address
•
Server Port
•
User Domain
•
Base Domain Filter
•
Administrator Security Group
•
Supervisor Security Group
and/
or
Operator Security Group.
5.
Press
TEST
to log in to a Windows account in order to
verify the information entered.
NOTE:
Contact your network administrator if the
instrument cannot access the server over the
network.
6.
Press
SAVE
.
