Safe use
4
General cautions
•
This product should be operated only with the type of
power source indicated on the product’s electrical
ratings label. Refer to the installation instructions
included with the product.
•
If the power cord provided is replaced for any reason
or if an alternate cord is used, the cord must be
approved for use in the local country. The power cord
must be approved for the product’s listed operating
voltage and be rated at least 20% greater than the
volt-ampere (VA) ratings marked on the product’s
electrical ratings label. The cord end that connects to
the product must have an IEC 60320 connector.
•
Plug the product into an approved grounded electrical
outlet. Exposure to AC voltage could lead to electric
shock, burn or electrocution. Please be aware of any
exposure of AC voltage in the power cord.
•
Do not disable the power cord’s grounding pin.
•
If an extension cord or power strip is used, make sure
that the cord or strip is rated for the product, and that
the total ampere ratings of all products plugged into
the extension cord or strip do not exceed 80% of the
cord’s or strip’s rating limit.
•
Route power cords so that they will not be walked on,
tripped on, or pinched by items placed upon or
against them. Pay particular attention to the plug,
electrical outlet, and the point where the cord exits the
product.
•
Do not pull on cords and cables. When unplugging
cords or cables, grasp the corresponding connector.
•
Do not install or use this product in any area subject to
extreme short-term temperature variations, or
locations that exceed the specified operating
environment temperatures.
•
Never use this product in a wet area.
•
To avoid injury or fire hazard, do not operate this
product in an explosive atmosphere.
•
Do not install or use the product on an unstable,
non-level work surface.
•
Do not operate this product with the covers removed
or unsecured.
FCC requirements
WARNING:
Changes or modifications to this unit
not expressly approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference in
which case the user will be required to correct the
interference at his own expense.
If you have any questions or problems regarding the
operation of this instrument, please contact our technical
support department:
Advanced Instruments, LLC
Two Technology Way
Norwood, MA 02062, USA
Phone: 781-320-9000
Web:
or
Email:
or
Technical support/product service
Phone: U.S. and Canada 800-225-4034
+1 781-320-9000
Email:
Customer service/orders
Phone: 800-225-4034 or +1 781-320-9000
Email:
Содержание Anoxomat III
Страница 1: ...Anoxomat III User s Guide AN3005EN Rev 5 ...