4
SATA
Connectors
Standard 7Pin SATA connector to link to MB or HBA card.
HDD Fail LED Input
For some HBA supporting HDD Fail LED’s. If used, the jumper is used to connect to
cathode of the diode for HDD Fault output from HBA.
It’s left to open, as default, when HBA doesn’t support it.
Fan
Connectors
A 3-pin fan connector with failure detection
Pin Number
Description
1 GND
2
HDD 0 Fail Input
3
HDD 1 Fail Input
4
HDD 2 Fail Input
Pin Number
Description
1 GND
2 +12V
3 Tach
5
CHAPTER 2 INSTALLATION OVERVIEW
Warning
：
Before you remove or install the unit, make sure the unit is not turned on or
connected to the AC power.
2.1 Removing the HDD Tray from the enclosure
1. Press the latch to the right by the thumb.
2. Pull the tray door outward by the forefinger at the same time.
3. Remove the HDD tray from the enclosure
4. Install the four mounting screws to secure the drive in the disk tray.
Bottom view of HDD tray
5. Slide the tray into a slot. Press the tray handle until the latch is closed and locks into
place.