StraitEdge™ Inflatable Canoe Owner’s Manual
13
Do not store your canoe for an extended period of time while wet. Follow the steps below for
removing excess water.
1. Unzip the 2 zippers that run down the sides of the canoe.
2. Use a sponge or towel and wipe up any excess water in the outer cover.
3. Wipe off the floor (top and bottom).
4. If there is sand or gravel in the canoe, you can hose out the cover and then wipe it
down with a towel.
5. Most of the time you can just pull out the inflatable floor and wipe out the inside of the
canoe absorbing most of the water, then pack it up.
6. REPAIRS
All canoes come with a repair kit that includes glue and several patches. This should remain
with the canoe in the event that you may need it. If service is required for your canoe, please call
866-262-9076
for assistance.
6.1 Repairing Small Punctures and Cuts
1. Cut a rounded patch at least ¼” or ½” larger than the hole or cut.
2. Clean the area where the patch will be placed with water and/or mild soap.
3. Make sure all surfaces are dry.
4. In a well ventilated area, spread a thin layer of glue on both the patch and on the damaged
area. Let it sit for three to five minutes or until tacky.
6.2 Repairing Pinholes
1. Inflate the PVC tube. Locate the pinhole by sponging soapy water over the tube until
you see air bubbles. Mark the location of the pinhole.
2. Deflate the tube and dry the affected area. Apply a drop of glue to the pinhole
3. Allow glue to dry completely.
4. Do not inflate the canoe for at least twelve hours.
Содержание StraitEdge AE1008
Страница 16: ...16 NOTES...
