Advanced Bionics CI-6101, Инструкция по эксплуатации

Страница: 8 / 101

7
•
Clinical Programming Interface USB Cable — The
CPI-3 USB cable is connected to a PC USB port and
to the micro-USB port of the CPI-3. The CPI-3 USB
cable should be plugged into a high powered USB
port found directly on the PC. To switch off the CPI-3,
unplug the unit from the computer.
•
Sound processor —
The patient’s own sound
processor(s) is used during device fitting.
Depending on the type of processor being
programmed, the battery or the removable control
header may need to be removed to connect the
programming cable.
•
Programming Cable — Processor specific
programming cables are used to connect processors
to the CPI-3. A lock is available to help secure the
programming cable to the PSP. It slides onto the
sound processor like the battery. A cable lock is built
in to the Harmony & Auria programming cable.
Connecting the CPI-3 for Programming
1. Turn on your computer and have the SoundWave
software fully open and running.
2. Next, connect the CPI-3 to your computer. Do this by
connecting the USB cable 1 to the USB Port (micro-
USB) on the bottom of the CPI-3 (see Figure 2).
Connect the other end, into a USB port on your
computer.
1
Use only the USB Cable supplied by Advanced Bionics. Other
USB Cables may not work properly.