ADVANCE Easy Moving FIREPOD universal, Инструкция по сборке, использованию и обслуживанию

Страница: 18 / 24

Universal system instruction manual
125/10/21 Rev:1.0.1
18
When you want to fi ll the tank, proceed as follows:
a)
set the illuminated switch on the control panel to 1 and check that the switch lights up
b) open the suction inlet fl ap and insert the fl exible hose equipped with a lance
c) c) when the system starts the suction cycles, position the lance in the bag or in any other
container of the fuel to be aspirated. The suction lance must never be completely immersed
in the fuel to be sucked, the fl uidization grille placed in the front of the lance must always be
left free to suck air (see fi gure 27)
d) topping up can be interrupted at any time simply by lifting the lance from the fuel and
extracting the fl exible pipe from the suction inlet. Regardless, when the tank is full, the
suction cycles are interrupted automatically.
e) at the end of the operation, disconnect the fl exible pipe from the suction inlet and make sure
that the inlet fl ap is properly closed. In this way the system stops functioning.
f) if you do not intend to use the system for a long period, set the illuminated switch on the
control panel back to 0.
13 CORRECT USE OF THE SYSTEM
Figure 27
Now check that the duration of each suction cycle is long enough to fi ll the dispenser tank with the right
amount of fuel, at least up to half of its internal volume.
To make this check at the end of a suction cycle, keep the outlet door closed after completing a cycle
and turn off the system, then open the lid of the dispenser tank and check the contents.
Now use the trimmer located in the center of the control panel to change the time of the suction
cycles, at each click the time of the suction cycle changes by 2 seconds. Turning it clockwise with a
small screwdriver will lengthen the time and bring more fuel in the metering unit, vice versa, turning it
anticlockwise with each click, the time will shorten by 2 seconds and less fuel will be brought into the
metering unit.
There are 16 trimmer positions and they regulate the time of the suction cycles from 2 to 32 seconds.
The 0 seconds position is not present.
To completely fi ll the tank, continue holding the lance on the bulk fuel, until the operating cycles stop
automatically on their own.
The operating cycles cease when there is such a quantity of fuel in the tank that the lower door of the
dispenser tank is not closed.
At the end of the operation, always disconnect the fl exible hose from the wall inlet and make sure that
the inlet fl ap closes properly.