A-14 / ENGLISH
A-14
- FORM NO. - 56041972 - Warrior
™
ST, Warrior
™
EcoFlex
™
DETERGENT SYSTEM PREPARATION AND USE (ECOFLEX MODELS ONLY)
COMMON INSTRUCTIONS:
Pressing and releasing the Detergent Switch
(F)
while the solution system is active will cause the detergent system to alternately turn on and off.
The system should be purged of previous detergent when switching to a different detergent.
SERVICE
NOTE:
Move machine over
fl
oor drain
before purging because a small amount of detergent will be dispensed in the process.
To Purge When Changing Chemicals:
1
Disconnect and remove the detergent cartridge.
2
Turn the Key Switch
(A)
ON. Press and hold the Solution Switch
(B)
and
the Detergent Switch
(F)
down for 2 seconds.
NOTE:
Once
activated the purge process takes 10 seconds. See illustration on next page for Detergent System indicators. Normally one purge cycle is
adequate to purge the system.
To Purge Weekly:
1
Disconnect and remove the detergent cartridge. Install and connect a Cartridge
fi
lled with clean water
2
Turn the Key Switch
(A)
ON. Press and hold the Solution Switch
(B)
and
the Detergent Switch
(F)
down for 2 seconds.
NOTE:
Once
activated the purge process takes 10 seconds. See illustration on next page for Detergent System indicators. Normally one purge cycle is
adequate to purge the system.
When the Detergent Cartridge is almost empty a Display Panel
(D)
indicator will come on. This “Low Detergent” indicator will remain on until you
reset the system. Once this indicator comes on you should be able to simply pour an entire gallon bottle of detergent into the Cartridge to re
fi
ll
without worrying about measuring.
NOTE:
Only reset the system when the cartridge is full. When switching cartridges, the “Low Detergent”
indicator is only accurate if the replacement cartridge is at the same level as the cartridge being replaced.
To Reset:
1
Turn the Key Switch
(A)
ON. Press and hold the Detergent Switch
(F)
and the EcoFlex Switch
(G)
down for 2 seconds. See illustration on
next page for Detergent System indicators.
Detergent Ratio:
1
The detergent ratio is locked at 1:400, except while overriding the EcoFlex cleaning mode. The pre-programmed ratio that is used during
EcoFlex override can be adjusted. With the detergent system OFF, press and hold the Detergent ON/OFF Switch
(F)
for 2 seconds. The
detergent indicator will
fl
ash and each press of the switch will cycle through the available ratios (1:32, 1:50, 1:64, 1:100, 1:128, 1:150, 1:200,
1:256, 1:300, 1:400). Once the desired ratio is displayed on the screen
(D4)
, stop and it will lock in after 5 seconds.
CARTRIDGE SPECIFIC INSTRUCTIONS:
Fill the detergent cartridge with a maximum of 1.25 gallons (4.73 Liters) of detergent.
SERVICE NOTE:
Remove the detergent cartridge from the
detergent box prior to
fi
lling to avoid spilling detergent on the machine.
It is recommended that a separate cartridge be used for each detergent you plan to use. The detergent cartridges have a white decal on them so
you can write the detergent name on each cartridge to avoid mixing them up. When installing a new cartridge, remove the Cap
(AA)
and place the
cartridge in the detergent box. Install the Dry Break Cap
(BB)
as shown.