SERVICE MANUAL
ENGLISH
Adinity™ 17 ST / 20 ST / 20 D / X 20 D / X 20 C / X 24 D
9096982000(2)2009-06
7
GENERAL INFORMATION
WARNING!
To avoid any unauthorized use of the machine, remove the ignition key.
–
Do not leave the machine unattended without being sure that it cannot move independently.
–
Always protect the machine against the sun, rain and bad weather, both under operation and inactivity
–
condition. Store the machine indoors, in a dry place: This machine must be used in dry conditions, it must
not be used or kept outdoors in wet conditions.
Before using the machine, close all doors and/or covers.
–
Do not allow to be used as a toy. Close attention is necessary when used near children.
–
Use only as shown in this Manual. Only Advance recommended accessories must be used.
–
Take all necessary precautions to prevent hair, jewels and loose clothes from being caught by the machine
–
moving parts.
Do not use the machine on slopes with a gradient exceeding the speciications.
–
Do not use the machine in particularly dusty areas.
–
While using this machine, take care not to cause damage to people or objects.
–
Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
–
Do not put any can containing luids on the machine.
–
The machine working temperature must be b32°F and +104°F (0°C and +40°C).
–
The machine storage temperature must be b32°F and +104°F (0°C and +40°C).
–
The humidity must be between 30% and 95%.
–
When using loor cleaning detergents, follow the instructions on the labels of the detergent bottles.
–
To handle loor cleaning detergents, wear suitable gloves and protections.
–
Do not use the machine as a means of transport.
–
Do not allow the brushes to operate while the machine is stationary to avoid damaging the loor.
–
In case of ire, use a powder ire extinguisher, not a water one.
–
Do not tamper with the machine safety guards and follow the ordinary maintenance instructions
–
scrupulously.
Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged.
–
Always keep the openings free from dust, hairs and any other foreign material which could reduce the air
low.
Do not remove or modify the plates afixed to the machine.
–
This machine cannot be used on roads or public streets.
–
Pay attention during machine transportation when temperature is below freezing point. The water in the
–
recovery tank or in the hoses could freeze and seriously damage the machine.
Use brushes and pads supplied with the machine and those speciied in the User Manual. Using other
–
brushes or pads could reduce safety.
In case of machine malfunctions, ensure that these are not due to lack of maintenance. Otherwise, request
–
assistance from the authorised personnel or from an authorised Service Center.
If parts must be replaced, require ORIGINAL spare parts from a Dealer or Authorised Retailer.
–
To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of
–
this Manual, must be performed by the authorised personnel or by an authorised Service Center.
Carefully read all the instructions before performing any maintenance/repair procedure.
–
Do not wash the machine with direct or pressurised water jets, or with corrosive substances.
–
The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries,
–
etc.), which are subject to standards that require disposal in special centres (see the User Manual).
Do not pull or carry the machine by the battery charger cable and never use the battery charger cable as
–
a handle. Do not close a door on the battery charger cable, or pull the battery charger cable around sharp
edges or corners. Do not run the machine on the battery charger cable.
Keep the battery charger cable away from heated surfaces.
–
Do not charge the batteries if the battery charger cable or the plug are damaged. If the machine is not
–
working as it should, has been damaged, left outdoors or dropped into water, return it to the Service Centre.
Before using the battery charger, ensure that frequency and voltage values, indicated on the machine serial
–
number plate, match the electrical mains voltage.
Do not smoke while charging the batteries.
–
To reduce the risk of ire, electric shock, or injury, do not leave the machine unattended when it is plugged
–
in. Before performing any maintenance procedure, disconnect the battery charger cable from the electrical
mains.
Содержание Adinity 17ST
Страница 2: ......
