ADTRAN Total Access 912, Руководство по установке оборудования

Страница: 25 / 44

Total Access 900 Series Hardware Installation Guide Unit Installation
61210916L1-34A Copyright © 2005 ADTRAN, Inc. 25
3. UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics such as
wallmounting/rackmounting the unit and installing the unit. See
Unpack and Inspect the System on page 20
before getting started. These instructions are presented as follows:
• Tools Required on page 25
• Mounting Options on page 26
• Grounding Instructions on page 27
• Supplying Power to the Unit on page 28
For information on configuration for a specific application, refer to the quick configuration documents
provided on your
ADTRAN OS Documentation CD. For details on the command line interface, refer to the
AOS Command Reference Guide (also included on your CD).
Tools Required
The following customer-provided tools are required for the hardware installation of the Total Access 900
Series:
• Two wood screws, 3/32-inch to 1/8-inch (1 1/2-inches length)
• Drill and drill bit set
• Screwdriver (medium)
• 25-pair male amphenol cable (customer connection)
• Selected punch-down block and tool
To prevent electrical shock, do not install equipment in a wet location or during an
electrical storm.
To access the command line interface (CLI) of the Total Access 900 Series, you must have
a VT100 terminal or PC with terminal emulation software and a
CRAFT
port cable.
Instructions on how to access the CLI are given in the AOS Command Reference Guide
(provided on the ADTRAN OS Documentation CD).
To access the Web-Based GUI of the Total Access 900 Series, you must have a PC
connected to an IP network. Instructions on how to access the Web-Based GUI are given in
the Web GUI Configuration Guide, document number 61210916L1-42.1 (provided on the
ADTRAN OS Documentation CD).