Quick Configuration Guide (QCG)
TA 900/900e E&M Wink Trunk Quick Start Guide
Overview
This Configuration Guide explains how to configure a T1 port on the Total Access
900/900e for a Robbed Bit Signaling T1 to be connected to a PBX or other CPE
device that requires an E&M WInk connection.
Requirements & Limitations
In the TA 900 series, only T1 port 0/2 can be used for an E&M Wink connection.
In the TA 900e series, T1 ports 0/3 and 0/4 can be used for E&M Wink
connections.
Web Interface Configuration
Configuring the Local Dialing Type
First, we must set the Local Dialing Type to 7 or 10 digits. To do this, begin by
clicking on ‘Dial Plan’ under ‘Voice’.
Then, select the appropriate 7 or 10 Digit Dialing for local calls and click on
‘Apply’.
Configuring the T1 Interface
