Quick Start Guide, 61200825G1-13A, February 2011
1
N
ET
V
ANTA
O
CTAL
P
O
E U
PGRADE
P/N 4200825G1#120, 4200825G1#240
4
Copyright © 2011 ADTRAN, Inc. All Rights Reserved.
G
ETTING
S
TARTED
The NetVanta Power over Ethernet (PoE) Upgrade provides the ability to detect attached
powered devices (PDs) and deliver 48 VDC to the PDs via existing CAT 5 cabling. The NetVanta
PoE Upgrade bundle is shipped with the Octal PoE module, two standoffs, the PoE power supply,
and appropriate power cords.
I
NSTALLING
THE
O
CTAL
P
O
E M
ODULE
1.
Remove power and all connecting cables from the unit.
2.
Remove any installed network interface modules (NIMs), the screws holding the base unit
and the cover together, the two jack screws from the back panel (if necessary), and the two
mounting brackets (if necessary).
3.
Carefully lift and remove the unit’s cover to expose the main circuit board.
4.
Remove and retain the two PC board mounting screws (highlighted in
).
5.
Thread and secure the two standoffs (supplied with the Octal PoE module) into the two
holes from which you removed the PC board mounting screws (see
).
6.
Carefully align the 34-pin receptacle on the Octal PoE module with the 34-pin header
located on the circuit board. Applying even pressure, press the module until it is well seated.
7.
Align the holes in the standoffs with the holes in the Octal PoE module. Attach the module to
the standoffs using the two previously removed PC board mounting screws.
8.
Replace the unit cover, screws, mounting brackets, NIMs, and all connecting cables.
9.
If wall mounting the power supply, skip to steps given in
.
10. Restore power to the unit following the instructions in
.
Installation of the NetVanta Octal PoE module is not required on factory-
installed upgrades.
The NetVanta Octal PoE module is intended to be installed only by
qualified service personnel.
P
OWERING
THE
N
ET
V
ANTA
AND
P
O
E S
WITCHPORTS
1.
Plug the 2-pin connector from the PoE power supply into the
PoE
receptacle on the rear
panel of the NetVanta base unit.
2.
Plug the female end of the power supply’s power cord into the
AC Input
receptacle on the
power supply.
3.
Connect the other end (3-prong plug) of the PoE power supply’s power cord to the proper
100 to 130 VAC or 190 to 250 VAC receptacle.
4.
Plug the NetVanta base unit‘s power cord into the
AC Input
receptacle on the rear of the
unit.
5.
Connect the other end (3-prong plug) of the NetVanta base unit’s power cord to the proper
100 to 130 VAC or 190 to 250 VAC receptacle.
The NetVanta PoE power supply and the NetVanta base unit with
which it is associated both should be installed in a restricted
access location as described in UL 60950-1.
Under full load, the NetVanta PoE power supply may be hot to the
touch.
The NetVanta PoE power supply is intended
•
to be installed, maintained, and serviced by qualified service
personnel only.
•
for use only with NetVanta units with the Octal PoE Upgrade
module installed.
•
This unit shall be installed in accordance with Articles 300 and 400
of NEC NFPA 70.
•
Power to the AC system must be from an appropriately rated and
grounded source.
•
Maximum recommended ambient operating temperature is 50
o
C.
