2
Copyright © 2009 ADTRAN, Inc. All Rights Reserved.
Quick Start Guide, 61200823G1-13A, March 2009
3
C
ONFIGURE
THE
U
NIT
’
S
IP A
DDRESS
The following steps create an IP address and subnet mask for
ETH 0/1
. If you are not sure what
IP address to assign, please contact your network administrator.
1.
At the
#
prompt, enter
config terminal
.
2.
At the
(config)#
prompt, enter
interface eth 0/1
to access the configuration parameters for
the Ethernet port located on the rear of the unit.
3.
Enter
ip address 10.26.12.12 255.255.255.0
to assign an IP address to the Ethernet port
using a 24-bit subnet mask.
4.
Enter
ip route 0.0.0.0 0.0.0.0 192.22.72.2
to add a default route to the route table. If
necessary, contact your network administrator to obtain the IP address (and subnet mask)
for your particular configuration.
5.
Enter
no shutdown
to activate the interface to pass data.
6.
Enter
exit
to exit the Ethernet interface commands and return to the Global Configuration
mode.
E
NABLE
T
ELNET
A
CCESS
The following steps create a password of
adtran
for Telnet access. By default, Telnet access is
enabled with a password of
password
.
1.
Verify that the prompt of your unit displays
(config)#
.
2.
Enter
line telnet 0 4
to change the configuration parameters for the Telnet sessions.
3.
Enter
login
to initiate Telnet access.
4.
Enter
password adtran
to change the login password for the Telnet sessions.
5.
Enter
exit
to return to the Global Configuration mode.
6.
Verify that the prompt of your unit displays
(config)#
.
7.
Enter
do write memory
to save the current configuration.
The configuration parameters used in the examples outlined in this
document are for instructional purposes only. Please replace all
underlined entries (
example
) with your specific parameters to configure
your application.
Depending on your configuration, you may need to set a default gateway
as well using the
(config)#ip default gateway
command. If IP routing is
enabled on the unit, do NOT set a default gateway.
C
ONFIGURE
Y
OUR
A
PPLICATION
More detailed documentation for configuring your ADTRAN unit is provided on the
AOS
Documentation
CD included in your shipment. For more detail on hardware setup, refer to the
appropriate NIM quick start guides and the hardware installation guide. For more detail on
configuring your system, refer to the
AOS Command Reference Guide
, configuration guides, and
technical support notes.
Important:
For additional details on product features, specifications,
installation, and safety, refer to the appropriate hardware installation
guide on the
AOS Documentation
CD shipped with the base unit and
available online at www.adtran.com.
C
ONSOLE
P
INOUTS
Pin
Name
Description
1
DCD
Data Carrier Detect (output)
2
RD
Receive Data (output)
3
TD
Transmit Data (input)
4
DTR
Data Terminal Ready (input)
5
SG
Signal Ground
6
—
Tied to Pin 1 (output)
7
—
Unused
8
—
Tied to Pin 1 (output)
9
—
Unused
E
THERNET
P
INOUTS
Pin
Name
Description
1
TX1
Transmit Positive
2
TX2
Transmit Negative
3
RX1
Receive Positive
4, 5
—
Unused
6
RX2
Receive Negative
7, 8
—
Unused
