ADTRAN NetVanta 3200 series, Руководство по установке оборудования

Страница: 64 / 90

Unit Installation NetVanta 3200/3300/3400 Series
64 Copyright © 2012 ADTRAN, Inc. 61200860L1-34AB
Figure 29. Wall Mounting the NetVanta 3200
Instructions for Wall Mounting NetVanta 3200
Step Action
1 Decide on a location for the unit. Keep in mind that the unit needs to be mounted at or below eye level so
that the LEDs are viewable.
2 Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick) to a wall
stud using #6 to #10 (2.5-inch or greater in length) wood screws.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
3 Install two #8 PAN head screws (1-inch or greater in length) into the mounted board, following these
guidelines and referring to
Figure 29 .
• Screws should be spaced horizontally, approximately 5 inches apart. Find exact positioning by using
the location of the two keyed insets on the bottom of the unit as a guide.
• Screws should be horizontally level with each other.
• Leave approximately 1/4-inch of the screws protruding from the board to allow the heads of the screws
to slide into place in the unit’s keyed insets.
4 Slide the keyed insets on the bottom of the unit’s chassis securely onto the screws.
5 Proceed to the steps given in Supplying Power to the Unit on page 69 .